Consumers - SBG6900-AC (v1.5.x): WPS PBC Setup
FAQs

Coronavirus (COVID-19) Disruption

“Our Call Center is experiencing a high number of calls due to the COVID-19 situation. We are working to assist everyone who contacts us. In the meantime, please visit www.arris.com/selfhelp for most frequently asked questions about your device. We apologize for the inconvenience and will assist you soon.”

ARRIS Consumer Care

Article

SBG6900-AC (v1.5.x): WPS PBC Setup

« Go Back

Information

 
Question
How do I enable WPS PBC on my SBG6900-AC?
Answer
The WPS (Wireless Protected Setup) feature allows wireless clients and the SBG6900-AC to establish a wireless connection with a push of a button or by exchanging pin code.  WPS and WPA-PSK (Wireless Protected Access) wireless encryption are enabled by default in the SBG6900-AC.  WPS automatically generates a new strong WPA key for the Gateway and any WPS client devices on the wireless network.  The SBG6900-AC supports two types of WPS: PIN Entry and PBC (Push Button Connection).  This document provides information on:

NOTE: The wireless clients must meet the following requirements for a WPS connection.

Requirements

  • Wireless client must support WPS.
The client's WPS must support hardware or software Push-button.

NOTE 1: Not all client wireless devices support WPS.  Please refer to the wireless client's documentation.

NOTE 2: Older, non-WPS clients can still be added to the network by configuring them with WEP or WPA-PSK.

 
Enable WPS PBC
 
  1. Launch a web browser, such as Internet Explorer, Firefox, or Safari. Enter http://192.168.0.1 into the address box, and press the Enter key.  The Login page appears.

    NOTE: By default the LAN IP address is 192.168.0.1.  If the default address has been changed, enter the custom address in the address box.

    User-added image

     
  2. On the Login page, enter admin in the Username field.
  3. Enter password in the Password field.
  4. Click the Login button.  The Home page appears.

    Image

     
  5. On the Home page, click on Manage Wi-Fi Network.  The Wireless - Primary Network Settings page appears.

    Image

     
  6. On the Wireless - Primary Network Settings page, WPS - Select the Enabled option.
  7. Click the Apply button.

    NOTE: The settings will take effect immediately.  Restarting the gateway is not required.

    Image

     
Establish WPS Push-button Connection
 
  1. Push and hold down the Pairing Button on the top panel of the SBG6900-AC for 10 seconds to begin exchange.

    NOTE: Both of the Wireless LED lights on the front panel will flash Green and Amber color.

     
  2. Push the wireless client's WPS Push-button (PBC).

    NOTE: The exchange may last up to two minutes.

    Image

     
Verify WPS Push-button Connection
  1. Check the status on the wireless client WiFi utility.

Feedback

 

Was this article helpful?


   

Your feedback is appreciated.

Characters Remaining: 255

 

Print
-->