Consumers - SBG7580-AC: LED Lights Status
FAQs

ARRIS Consumer Care

Article

SBG7580-AC: LED Lights Status

« Go Back

Information

 
Question
What do the LED lights indicate on my SBG7580-AC?
Answer
This document describes the function of the front panel LED lights on the SBG7580-AC.

Front Panel

User-added image

 
LED IconBlinking BlueOn (Solid Blue)
PowerNot applicable - icon does not blink.Power is properly connected.
Send/ReceiveScanning for upstream (Send) and
downstream (Receive) channel
connections. 
Upstream (Send) and Downstream
(Receive) channels are connected.
OnlineScanning for an Internet connection.Gateway is connected to the network.
Wireless 2.4 GHzWi-Fi enabled with encrypted or unencrypted wireless data activity.

Any of the following applies:

2.4 GHz wireless connection is made
between the SBG7580-AC and another   Wi-Fi enabled wireless device on your
home network; for example Wi-Fi
telephone, tablet, or laptop.

The WPS Pairing process between the
SBG7580-AC and WPS-enabled
wireless device was successful.

The WPS Pairing process either failed
or did not complete after two minutes. 

Wireless 5 GHzWi-Fi enabled with encrypted or unencrypted wireless data activity.Any of the following applies:

5 GHz wireless connection is made
between the SBG7580-AC and another   Wi-Fi enabled wireless device on your
home network; for example Wi-Fi
telephone, tablet, or laptop.

The WPS Pairing process between the
SBG7580-AC and WPS-enabled
wireless device was successful.

The WPS Pairing process either failed
or did not complete after two minutes. 
WPSWPS Pairing process is underway
between the SBG7580-AC and a 
WPS-enabled wireless device.
WPS-enabled wireless device is connected.
USBNot applicable - no LED on port.Not applicable - no LED on port.

Back Panel

User-added image

 
NameDescription
Reset ButtonRecessed button located on the rear panel of the wireless gateway can be used to either reboot the gateway or reset the gateway configuration settings.
To reboot (or restart) the wireless gateway:
1. Insert the end of a paper clip or other small object with a narrow tip into the Reset opening on the rear panel of the wireless gateway.
2. Press and hold the indented Reset button for three to four seconds only.
3. Remove the paper clip or small object from the Reset opening.
To reset the wireless gateway configuration back to the factory default settings:
1. Insert the end of a paper clip or other small object with a narrow tip into the Reset opening on the rear panel of your wireless gateway.
2. Press and hold the Reset button for 10 seconds.
3. Remove the paper clip or small object from the Reset opening. 
Ethernet 10/100/1000Four one-gigabit Ethernet ports for RJ-45 network cable connections:
Green: LED is ON - Indicates a data transfer rate of one gigabit per second
Green: LED is Blinking - Indicates data traffic is in progress
Amber: LED is ON - Indicates a data transfer rate of less than one gigabit per second
Amber: LED is Blinking - Indicates data traffic is in progress
CableCoaxial cable connector
Power100 - 240 VAC Power connector

Feedback

 

Was this article helpful?


   

Your feedback is appreciated.

Characters Remaining: 255

 

Print
-->