Consumers - SBV3202: Web Manager Access
FAQs

ARRIS Consumer Care

Article

SBV3202: Web Manager Access

« Go Back

Information

 
Question
How do I access the Web Manager for the SBV3202 cable modem?
Answer
Firmware version 9.1.103AA65L and later includes a new feature of Web Manager login using credentials.  Units with older firmware will not be prompted for login credentials and the Status page will appear.  The default admin login credential is admin (username) and password (password).  If the admin login password is at default, the Login Setting screen will appear to change the admin password.  It is required to change the admin password before accessing the Web Manager.  The Web Manager is used to view and monitor the network configuration settings and operational status of the SBV3202 cable modem.  

If logging into the Web Manager with the customized admin password is unsuccessful, the only option is to perform a factory reset on the SBV3202 to login with the default admin password.  Performing a Factory Reset will erase any configuration changes that have been made and will require the gateway to be reconfigured.  For instructions on how to do a factory reset, please refer to Answer # 17706 - SBV3202: Reset Button.  This document describes how to login to the Web Manager.


Accessing the Web Manager
  1. Launch a web browser, such as Internet Explorer, Firefox, or Safari.  Enter http://192.168.100.1 into the address box.  The Login page will appear.  

    NOTE 1: On firmware version 9.1.103AA65L and later the "UNTRUSTED CERTIFICATE" warning message may appear to block access to the Web Manager.  The message appears as the device does not have an authentication certificate.  There is NO risk in accepting the message and proceeding to 192.168.100.1 to access the Web Manager.

    NOTE 2: The Login page will not appear on units with older firmware, instead the Status page will appear.

     
  2. On the Login page, enter admin in the Username field.
     
  3. Enter password in the Password field then click the Apply button.  The Login Setting page will appear. 

    User-added image

     
  4. Enter password in the Old Password field.
     
  5. Enter a new password in the New Password field and re-enter the new password in the Repeat New Password field.

    Password Requirements:
    • Minimum of 8 characters
    • At least one uppercase alpha character
    • At least 1 number
    • One of ~ ! @ # $ % ^ * (  ) - _ = + [ ] { } | ; : , . / ?
  6. Click the Apply button.  The Login page will appear.    

    User-added image

     
  7. Enter admin in the Password field.
     
  8. Enter the custom password in the Password field then click the Apply button.  The Status page will appear. 
     
    User-added image

     
  9. A brief description of each menu page in the SBV3202 is listed below.

    User-added image

    NOTE: The CM FeatureLogin Settings, and Logout pages are available on firmware version 9.1.103AA65L and later. 
  • Status - Provides information about the startup process of the Cable Modem.
  • HW/FW Version - Provides information about the hardware and firmware version of the unit.
  • Event Log - Provides diagnostic messages generated by the Cable Modem, which is intended for use by a qualified technician.
  • CM State - Provides information about the status of the Cable Modem's HFC and IP network connectivity.
  • ISP Use Only - Used by qualified technicians. 
  • CM Feature - Provides the options for turn on the front panel LEDs and Energy Efficient Ethernet 
  • Login Settings - Provides the option to change the admin password.
  • Logout - Logout of the SBV3202 Web Manager.

Feedback

 

Was this article helpful?


   

Your feedback is appreciated.

Characters Remaining: 255

 

Print
-->