Consumers - SVG2482AC: LED Light Status
FAQs

ARRIS Consumer Care

Article

SVG2482AC: LED Light Status

« Go Back

Information

 
Question
What do the LED lights indicate on my SVG2482AC Gateway?
Answer
This document describes the function of the front panel LED lights on the SVG2482AC.

Front Panel

User-added image

 
LED IconBlinkingOn (Solid)
WPSWPS Pairing process is in progress.Not applicable - LED will turn OFF after the WPS-enabled device is connected.
PowerNot applicable- LED does not blink.Power is properly connected with power cord and the battery is not connected.
US/DSScanning for Upstream (Send) or Downstream (Receive) channel connection.Upstream (Send) and Downstream (Receive) channels are connected.
OnlineScanning for an Internet connection.SVG2482AC is connected to the home network.
Wireless 2.4 GHz

Any of the following applies:

  • 2.4 GHz wireless connection is made between the SVG2482AC and another Wi-Fi enabled device on the home network.
  • The WPS Pairing process between the SVG2482AC and the WPS-enabled device was successful.

 

Not applicable -  LED does not light up solid.

Wireless 5 GHz

Any of the following applies:

  • 5 GHz wireless connection is made between the SVG2482AC and another Wi-Fi enabled device on the home network.
  • The WPS Pairing process between the SVG2482AC and the WPS-enabled device was successful.

Not applicable -  LED does not light up solid.

Tel¹Telephone line 1 is dialing or call is in progress.Telephone service for line 1 is connected and activated; on-hook.
Tel²Telephone line 2 is dialing or call is in progress.Telephone service for line 2 is connected and activated; on-hook.
BatteryBattery is installed.Not applicable - LED does not light up solid. 

Back Panel

User-added image

 
NameDescription
Reset ButtonRecessed button located on the rear of the SVG2482AC can be used to
restart the gateway.
USBUSB 2.0 port connection to power on your USB device(s)
Telephone Line
Port (1 & 2)
Two telephony ports for RJ-11 cable connections:
VoIP connection for a single or two-line telephone
VoIP connection for a single-line telephone
Ethernet
10/100/1000
Four one-gigabit Ethernet ports for RJ-45 cable connections:
Yellow: LED is ON - Indicates a data transfer rate of one gigabit per second
Yellow: LED is Blinking - Indicates data traffic is in progress
Amber: LED is ON - Indicates a data transfer rate of less than one gigabit
per second
Amber: LED is Blinking - Indicates data traffic is in progress
CableCoaxial cable connector
MoCAMoCA LED:
ON – MoCA is enabled
OFF – MoCA is disabled
Note: This is a Comcast feature along with other components that Comcast must install.
Power115 VAC Power Input connector

Feedback

 

Was this article helpful?


   

Your feedback is appreciated.

Characters Remaining: 255

 

Print
-->